SPEED SENSOR > REMOVAL |
| 1. REMOVE NO. 2 CYLINDER HEAD COVER |
![]() |
Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.
| 2. REMOVE AIR CLEANER CAP AND HOSE |
![]() |
Disconnect the mass air flow meter connector.
Detach the clamp.
![]() |
Disconnect the No. 2 ventilation hose from the cylinder head cover.
Squeeze the taps of the air cleaner hose clamp, and then disconnect the air cleaner hose from the throttle body.
![]() |
Detach the 2 hook clamps, and then remove the air cleaner cap and hose.
| 3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp from the air cleaner case.
Remove the 3 bolts and air cleaner case.
| 4. REMOVE TRANSMISSION REVOLUTION SENSOR (NT) |
![]() |
Disconnect the transmission revolution sensor connector.
Remove the bolt and transmission revolution sensor.
Remove the O-ring from the transmission revolution sensor.
| 5. REMOVE TRANSMISSION REVOLUTION SENSOR (NIN) |
![]() |
Disconnect the transmission revolution sensor connector.
Remove the bolt and transmission revolution sensor.
Remove the O-ring from the transmission revolution sensor.
| 6. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT) |
![]() |
Disconnect the transmission revolution sensor connector.
Remove the bolt and transmission revolution sensor.
Remove the O-ring from the transmission revolution sensor.