SFI SYSTEM > DIAGNOSIS SYSTEM |
| EURO-OBD (EUROPE) |
![]() |
The emission control system components
The power train control components (which affect vehicle emissions)
![]() ![]() |
The computer
In addition, if the applicable Diagnostic Trouble Codes (DTCs) prescribed by ISO 15765-4 are recorded in the ECM memory. If the malfunction does not reoccur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| M-OBD (EXCEPT EUROPEAN SPEC.) |
![]() |
The emission control system/components
The power train control components (which affect vehicle emissions)
The computer
In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.
| NORMAL MODE AND CHECK MODE |
| 2-TRIP DETECTION LOGIC |

| DLC3 (Data Link Connector 3) |
| Symbol | Terminal No. | Name | Reference terminal | Result | Condition |
| SIL | 7 | Bus "+" line | 5 - Signal ground | Pulse generation | During transmission |
| CG | 4 | Chassis ground | Body ground | 1Ω or less | Always |
| SG | 5 | Signal ground | Body ground | 1Ω or less | |
| BAT | 16 | Battery positive | Body ground | 9 to 14 V | |
| CANH | 6 | CAN "High" Line | 14 - CANL | 54 to 69 Ω | Ignition switch off* |
| Battery positive | 6 kΩ or higher | ||||
| 4 - CG | 200 Ω or higher | ||||
| CANL | 14 | CAN "Low" Line | Battery positive | 6 kΩ or higher | |
| 4 - CG | 200 Ω or higher |
| INSPECT BATTERY VOLTAGE |
| CHECK MIL |
Check that the MIL illuminate when the ignition switch is turned on (IG).
If the MIL does not illuminate, there is a problem in the MIL circuit (Click here).
When the engine is started, the MIL should turn off.