SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (Using an intelligent tester) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menu items: Powertrain / Engine and ECT / DTC.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Using an intelligent tester) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menu items: Powertrain / Engine and ECT / DTC / Clear.
Press the YES button.
| CLEAR DTC (Without using an intelligent tester) |
Perform either one of the following operations:
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI and ETCS fuses from the engine room No. 1 relay block and junction block located inside the engine compartment for more than 1 minute.