SFI SYSTEM > FAIL-SAFE CHART |
| DTC Code | Component | Fail-Safe Operation | Fail-Safe Deactivation Condition |
| P0011 | VVT system |
| Pass condition is detected and then ignition switch is turned off |
| P0031, P0032 and P101D | Air fuel ratio sensor heater | The ECM turns off the air fuel ratio sensor heater. | Ignition switch is turned off |
| P0037, P0038 and P102D | Heated oxygen sensor heater | The ECM turns off the heated oxygen sensor heater. | Ignition switch is turned off |
| P0102 and P0103 | Mass air flow meter | The ECM calculates the ignition timing according to the engine speed and throttle valve position. | Pass condition is detected |
| P0105, P0107 and P0108 | Vacuum sensor | The intake air pressure is adjusted using a value calculated according to the throttle valve opening angle and engine speed. The engine speed is limited to 3000 rpm or less. | Pass condition is detected |
| P0112 and P0113 | Intake air temperature sensor | The ECM estimates the intake air temperature to be 20°C (68°F). | Pass condition is detected |
| P0115, P0117 and P0118 | Engine coolant temperature sensor | The ECM estimates the engine coolant temperature to be 80°C (176°F). | Pass condition is detected |
| P0136 | Heated oxygen sensor | Air fuel ratio feedback control is stopped. | Ignition switch is turned off |
| P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135 | Electronic throttle control system | The ECM cuts off throttle actuator current and the throttle valve is returned to a 5.5° opening angle by the return spring. The ECM then adjusts the engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal position to allow the vehicle to continue at minimal speed*1. | Pass condition is detected and then ignition switch is turned off |
| P0171 and P0172 | Fuel trim | Air fuel ratio feedback control is stopped. | Pass condition is detected and then ignition switch is turned off |
| P0300, P0301, P0302, P0303 and P0304*3 |
| When a misfire occurs, fuel cut is performed for catalyst overheat malfunction prevention.
| Pass condition is detected and then ignition switch is turned off |
| P0327 and P0328 | Knock sensor | The ECM sets the ignition timing to maximum retard. | Ignition switch is turned off |
| P0351, P0352, P0353 and P0354 | Igniter | The ECM cuts the fuel. | Pass condition is detected |
| P1046, P1047, P1049, P104A, P1055, P2646, P2647, P2648, P2649, P264A and U011B | VALVEMATIC system | Power to the continuously variable valve lift controller assembly is cut.*2 VVT (IN): The adjustable range is limited. VVT (EX): Fixed at a set value. | Ignition switch is turned off |
| P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138 | Accelerator pedal position sensor | The accelerator pedal position sensor has 2 sensor circuits: Main and Sub. If either circuit malfunctions, the ECM controls the engine using the other circuit. If both circuits malfunction, the ECM regards the accelerator pedal as being released. As a result, the throttle valve is closed and the engine idles. | Pass condition is detected and then ignition switch is turned off |