DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |
DTC P0020 Camshaft Position "A" Actuator Circuit (Bank 2) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in OCV for intake camshaft (bank 1) circuit (1 trip detection logic) |
|
| P0020 | Open or short in OCV for intake camshaft (bank 2) circuit (1 trip detection logic) |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (OPERATE OCV) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Warm up the engine.
On the tester, enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1) or Control the VVT System (Bank 2).
Check the engine speed while operating the Oil Control Valve (OCV) using the tester.
| Tester Operation | Specified Condition |
| OCV OFF | Normal engine speed |
| OCV ON | Engine idles roughly or stalls (soon after OCV switched from OFF to ON) |
|
| ||||
| NG | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (FOR INTAKE CAMSHAFT) |
![]() |
Disconnect the intake camshaft OCV connector.
Measure the resistance between the terminals of the OCV.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
Reconnect the OCV connector.
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (OCV - ECM) |
![]() |
Disconnect the intake camshaft OCV connector.
Disconnect the ECM connector.
Measure the resistance between the terminals.
| Tester Connection | Specified Condition |
| OC1+ (B96-58) - B94-1 | Below 1 Ω |
| OC1- (B96-57) - B94-2 | Below 1 Ω |
| Tester Connection | Specified Condition |
| OC2+ (B96-52) - B78-1 | Below 1 Ω |
| OC2- (B96-51) - B78-2 | Below 1 Ω |
| Tester Connection | Specified Condition |
| OC1+ (B96-58) or B94-1 - Body ground | 10 kΩ or higher |
| OC1- (B96-57) or B94-2 - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| OC2+ (B96-52) or B78-1 - Body ground | 10 kΩ or higher |
| OC2- (B96-51) or B78-2 - Body ground | 10 kΩ or higher |
Reconnect the OCV connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||