NAVIGATION SYSTEM (for HDD) > Voice is not Recognized |
| 1.CHECK NAVIGATION SETTING |
![]() |
Enter the "Setup" screen by pressing the "SETUP" switch.
Select "Voice".
![]() |
Check that "Voice Recognition Guidance" is not off.
|
| ||||
| OK | |
| 2.CHECK MICROPHONE |
![]() |
Enter the "Microphone&Voice Recognition Check" mode (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
|
| ||||
| OK | ||
| ||