POWER WINDOW CONTROL SYSTEM > INITIALIZATION |
| INITIALIZE POWER WINDOW CONTROL SYSTEM (POWER WINDOW REGULATOR MOTOR ASSEMBLY (ON DRIVER SIDE)) |
Connect the battery and turn the ignition switch on (IG).
The AUTO Light of the power window regulator master switch flashes when the initialization preparation is complete.
*1: Fully open the driver door power window by pressing down the driver door power window switch, and continue pressing it for at least 6 seconds after the window is fully opened.
*2: Fully close the driver door power window by pulling up the switch, and continue pulling it up for at least 6 seconds after the window is fully closed.
The driver door power window position is reset (the pulse sensor is initialized), and the power window regulator master switch AUTO Light changes from flashing to continuous illumination to indicate that the initialization has been successfully completed.