FUEL SYSTEM > PRECAUTION |
| 1.EXPRESSIONS OF IGNITION SWITCH |
| Expression | Ignition Switch (position) | Engine Switch (condition) |
| Ignition Switch off | LOCK | Off |
| Ignition Switch on (IG) | ON | On (IG) |
| Ignition Switch on (ACC) | ACC | On (ACC) |
| Engine Start | START | Start |
| 2.BEFORE WORKING ON FUEL SYSTEM |
Do not work near an open flame.
Keep gasoline away from rubber and leather parts.
Discharge the fuel pressure before disconnecting the fuel line to prevent gasoline from spilling out. Refer to the following procedure.
| 3.DISCHARGE FUEL PRESSURE |
Remove the console box .
![]() |
Disconnect the connector.
Start the engine. After the engine has stopped, turn the ignition switch off.
Check that the engine does not start.
Remove the fuel tank cap, and let the air out of the fuel tank.
![]() |
Connect the connector.
Install the console box .
| 4.DISCONNECT FUEL MAIN TUBE |
![]() |
Remove the fuel tube from the fuel hose clamp.
Remove the fuel pipe clamp.
Wipe off any dirt on the fuel tube connector.
Hold the fuel tube connector, and then install the SST.
Turn the SST to align the retainer inside the fuel tube connector with the chamfered part of the SST.
Insert the SST into the fuel tube and hold it. Then push the fuel tube connector toward the SST side.
Mount the retainer of the fuel tube connector onto the chamfered part of the SST.
![]() |
Slide the SST and fuel tube connector together towards the fuel tube until they make a "click" sound, and then disconnect the fuel tube.
Drain the fuel remaining inside the fuel tube.
Cover the fuel tube and fuel pipe with a plastic bag to protect the disconnected part.
| 5.CONNECT FUEL MAIN TUBE |
Connect the fuel main tube.
Push the fuel tube connector until it makes a "click" sound.
Install the fuel pipe clamp.
Install the fuel tube to the fuel hose clamp.
| 6.DISCONNECT FUEL TUBE CONNECTOR |
![]() |
Wipe off any dirt on the fuel tube connector.
Pinch the fuel tube connector, and then disconnect the fuel tube. Do not use any tools.
Drain the fuel remaining inside the fuel tube.
Cover the fuel tube and fuel pipe with a plastic bag to protect the disconnected part.
| 7.CONNECT FUEL TUBE CONNECTOR |
Connect the fuel tube connector to the fuel pipe.
Push the fuel connector until it makes a "click" sound.
| 8.CHECK FOR FUEL LEAKS |
![]() |
Make sure that there are no fuel leaks after performing maintenance on the fuel system.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG), and push the intelligent tester main switch ON.
Select the Active Test mode on the intelligent tester.
Check that there are no leaks from the fuel system.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.