Home › ENGINE ยท 2GR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    A137899
  1. Remove the 9 clips and cover.



2. REMOVE V-BANK COVER SUB-ASSEMBLY


    A137900
  1. Detach the 3 clips and remove the V-bank cover.



3. DISCONNECT RADIATOR RESERVOIR TANK ASSEMBLY


    A178054
  1. Remove the 2 bolts and disconnect the reservoir tank.



4. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.



5. REMOVE REAR ENGINE UNDER COVER RH
  1. Remove the 2 clips and under cover.



6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A129514E01
  1. Remove the 4 bolts and reinforcement.



7. REMOVE V-RIBBED BELT


    A137895
  1. Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.



    A095070E01
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.