Home › ENGINE ยท 3ZR-FAE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A206200
  1. Remove the 6 screws, 10 clips and under cover.



2. REMOVE REAR ENGINE UNDER COVER RH


    A196892
  1. Remove the 3 clips and under cover.



3. REMOVE RADIATOR SUPPORT OPENING COVER


  1. Remove the 9 clips and radiator support opening cover.


    A226478E01



4. REMOVE NO. 2 CYLINDER HEAD COVER


    A209050
  1. Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

    NOTICE:
    Attempting to detach both front and rear clips at the same time may cause the cover to break.



5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



6. DRAIN ENGINE COOLANT


    A195000E02
  1. Install a vinyl hose to the drain cock plug on the radiator side.



  1. Loosen the radiator drain cock plug.


    A245378E01

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



7. REMOVE V-RIBBED BELT


    A165469E01
  1. Loosen bolts A and B.

  1. Loosen bolt C and remove the V-ribbed belt.

    NOTICE:
    Do not loosen bolt D.



8. REMOVE GENERATOR ASSEMBLY


    A169649
  1. Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the connector and wire harness clamp.



    A206588
  1. Loosen the 3 bolts.



    A205693
  1. Remove the 2 bolts and adjusting bar.



    A205694
  1. Remove the bolt and generator.



    A156000
  1. Remove the bolt and wire harness clamp bracket.



9. REMOVE WATER PUMP ASSEMBLY


    A156388
  1. Remove the 5 bolts and water pump from the timing chain cover.



    A162996E01
  1. Remove the gasket from the timing chain cover.