DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | When either condition below is met:
|
|
| P0339 | Under conditions (a), (b) and (c), no CKP sensor signal to ECM for 0.05 seconds or more (1 trip detection logic): (a) Engine speed 1,000 rpm or more (b) Starter signal OFF (c) 3 seconds or more have lapsed since starter signal switched from ON to OFF |
|
![]() |
| Item | Content |
| Terminals | CH1: G2+ - G2- CH2: NE+ - NE- |
| Equipment Settings | 5 V/DIV. 20 msec./DIV. |
| Conditions | Cranking or idling |

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT / Data List / Engine Speed.
Start the engine.
Read the values displayed on the tester while the engine is running.
|
| ||||
| NG | |
| 2.INSPECT CRANKSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the B22 Crankshaft Position (CKP) sensor connector.
Measure the resistance between terminals 1 and 2.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 985 to 1,600 Ω |
| 1 - 2 | Hot | 1,265 to 1,890 Ω |
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the B22 CKP sensor connector.
Disconnect the B32 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| NE+ (B22-1) - NE+ (B32-122) | Below 1 Ω |
| NE- (B22-2) - NE- (B32-121) |
| Tester Connection | Specified Condition |
| NE+ (B22-1) or NE+ (B32-122) - Body ground | 10 kΩ or higher |
| NE- (B22-2) or NE- (B32-121) - Body ground |
Reconnect the ECM connector.
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 4.CHECK SENSOR INSTALLATION (CRANKSHAFT POSITION SENSOR) |
![]() |
Check the CKP sensor installation.
|
| ||||
| OK | |
| 5.CHECK CRANKSHAFT POSITION SENSOR PLATE (TEETH OF SENSOR PLATE) |
Check the teeth of the sensor plate.
|
| ||||
| OK | |
| 6.REPLACE CRANKSHAFT POSITION SENSOR |
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS |
Connect an intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Clear DTCs (Click here).
Start the engine.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Display (DTC output) | Proceed to |
| No output | A |
| P0335 or P0339 | B |
|
| ||||
| A | ||
| ||