DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 |
|
|
| P0339 | Under conditions (a), (b) and (c), no CKP sensor signal to ECM for 0.05 seconds or more (1 trip detection logic): (a) Engine speed 1000 rpm or more (b) Starter signal OFF (c) 3 seconds or more have elapsed since starter signal switched from ON to OFF |
|
![]() |
| Item | Content |
| Terminal | VV1+ - VV1- VV2+ - VV2- NE+ - NE- |
| Equipment Setting | 5 V/DIV. 20 ms./DIV. |
| Condition | Cranking or idling |

| 1.INSPECT CRANKSHAFT POSITION SENSOR |
![]() |
Disconnect the crankshaft position (CKP) sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 1630 to 2740 Ω |
| 1 - 2 | Hot | 2065 to 3225 Ω |
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the CKP sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| B81-1 - NE+ (B96-110) | Below 1 Ω |
| B81-2 - NE- (B96-111) | Below 1 Ω |
| Tester Connection | Specified Condition |
| B81-1 or NE+ (B96-110) - Body ground | 10 kΩ or higher |
| B81-2 or NE- (B96-111) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the CKP sensor connector.
|
| ||||
| OK | |
| 3.CHECK CRANKSHAFT POSITION SENSOR (SENSOR INSTALLATION) |
![]() |
Check the CKP sensor installation condition.
|
| ||||
| OK | |
| 4.CHECK CRANKSHAFT POSITION SENSOR PLATE (TEETH OF SENSOR PLATE) |
Check the teeth of the sensor plate.
|
| ||||
| OK | ||
| ||