ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT VALVE LASH ADJUSTER NOISE |
Rev up the engine several times. Check that the engine does not emit unusual noises.
If unusual noises occur, warm up the engine and idle it for over 30 minutes. Then perform the inspection above again.
If any defects or problems are found during the inspection above, perform a lash adjuster inspection.
| 2. INSPECT IGNITION TIMING |
Warm up and stop the engine.
When using the intelligent tester:
Connect the intelligent tester to the DLC3.
Start the engine and idle it.
Turn the intelligent tester main switch on.
Enter the following menus: Powertrain / Engine and ECT / Data List / IGN Advance.
When not using the intelligent tester:
Remove the V-bank cover .
![]() |
Connect the tester terminal of a timing light to the red lead wire as shown in the illustration.
![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Using a timing light, check the ignition timing.
Remove SST from the DLC3.
Check the ignition timing.
Check that the ignition timing advances immediately when the engine speed is increased.
Disconnect the timing light from the engine.
Install the V-bank cover .
| 3. INSPECT ENGINE IDLE SPEED |
Warm up and stop the engine.
When using the intelligent tester:
Connect the intelligent tester to the DLC3.
Race the engine at 2500 rpm for approximately 90 seconds.
Turn the intelligent tester main switch on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Engine Speed.
Disconnect the intelligent tester from the DLC3.
![]() |
When not using the intelligent tester:
Using SST, connect the tachometer probe to terminal 9 (TAC) of the DLC3.
Race the engine at 2500 rpm for approximately 90 seconds.
Check the idle speed.
Disconnect the tachometer probe from the DLC3.
| 4. INSPECT COMPRESSION |
Warm up and stop the engine.
Disconnect the injector connectors.
Remove the intake air surge tank .
Remove the 6 ignition coils .
Remove the 6 spark plugs.
![]() |
Inspect the cylinder compression pressure.
Insert a compression gauge into the spark plug hole.
While cranking the engine, measure the compression pressure.
Perform the inspection above for each cylinder.
If the cylinder compression in one or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole. Then perform the first 3 steps under "Inspect the cylinder compression pressure" for the cylinders with low compression.
Install the 6 spark plugs.
Install the 6 ignition coils .
Install the intake air surge tank .
Connect the injector connectors.
| 5. INSPECT CO/HC |
Start the engine.
Keep the engine speed at 2500 rpm for approximately 180 seconds.
Insert a CO/HC meter testing probe at least 40 cm (1.3 ft.) into the tailpipe during idling.
Immediately check the CO/HC concentration at idle and/or 2500 rpm.
Check the air fuel ratio sensor and heated oxygen sensor operation.
See the table below for the possible cause, then inspect and correct the applicable causes if necessary.
| CO | HC | Symptom | Causes |
| Normal | High | Rough idle |
|
| Low | High | Rough idle (Fluctuating HC reading) |
|
| High | High | Rough idle (Black smoke from exhaust) |
|