SPEED SENSOR > INSPECTION |
| 1. INSPECT TRANSMISSION REVOLUTION SENSOR (NIN) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (NIN-) - 2 (NIN+) | 20°C (68°F) | 560 to 680 Ω |
| *1 | Component without harness connected (Transmission Revolution Sensor (NIN)) |
| 2. INSPECT TRANSMISSION REVOLUTION SENSOR (NT) |
Connect the battery to the sensor as shown in the illustration.
![]() |
Wave a magnetic object left and right in front of the tip of the transmission revolution sensor (5 mm (0.197 in.) gap or closer) to change the high/low signals while measuring the current.
Measure the current according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (NTO) - 2 (NTB) | Low Signal | 4 to 8 mA |
| 1 (NTO) - 2 (NTB) | High Signal | 12 to 16 mA |
| *1 | Component without harness connected (Transmission Revolution Sensor (NT)) |
| *2 | Ammeter |
| *3 | Magnetic Object |
| 3. INSPECT TRANSMISSION REVOLUTION SENSOR (NOUT) |
Connect the battery to the sensor as shown in the illustration.
![]() |
Wave a magnetic object left and right in front of the tip of the transmission revolution sensor (5 mm (0.197 in.) gap or closer) to change the high/low signals while measuring the current.
Measure the current according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (NOTO) - 2 (NOTB) | Low Signal | 4 to 8 mA |
| 1 (NOTO) - 2 (NOTB) | High Signal | 12 to 16 mA |
| *1 | Component without harness connected (Transmission Revolution Sensor (NOUT)) |
| *2 | Ammeter |
| *3 | Magnetic Object |