Home › STEERING › POWER STEERING › POWER STEERING ECU (for RHD)

POWER STEERING ECU (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING ECU


    C158026E01
  1. Check that the connector lever is at the fully unlocked position before installation.

    NOTICE:
    If the lever has been lifted out of the fully unlocked position, it may cause an imperfect connection.



    C128907E04
  1. Install the ECU with the 3 nuts.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the 4 connectors.

  1. Lock the connector lever.

  1. Lightly pull on the connector and check that the connector will not be disconnected.



2. INSTALL UPPER INSTRUMENT PANEL
  1. Install the upper instrument panel .



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL