CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
![]() |
Check if SST is functioning properly.
Follow the "Precaution" (Click here).
Disconnect the cable from the negative battery terminal. Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying.
Short body:
Remove the roof headlining assembly .
Long body:
Remove the roof headlining assembly .
Install SST.
Disconnect the connector from the curtain shield airbag assembly.
![]() |
After connecting SST to each other, connect them to the curtain shield airbag assembly.
![]() |
Move the SST at least 10 m (33 ft.) away from the vehicle rear side window.
Maintaining enough clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
Connect the SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE) |
![]() |
Check if SST is functioning properly.
Remove the curtain shield airbag .
![]() |
Cut off the deployment section of the curtain shield airbag.
![]() |
Using a service-purpose wire harness for the vehicle, tie down the curtain shield airbag to the tire.
![]() |
Position the curtain shield airbag assembly inside the tire as shown in the illustration.
Install SST.
![]() |
After connecting SST to each other, connect them to the curtain shield airbag.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the curtain shield airbag assembly is tied.
Place at least 2 tires over the tire to which the curtain shield airbag is tied. The top tire should have the disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
Install SST.
![]() |
Connect the SST connector.
Deploy the airbag.
Connect the SST's red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Check that no one is within a 10 m (33 ft) radius of the tire to which the curtain shield airbag is tied.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the curtain shield airbag.
Remove the curtain shield airbag from the tire.
Place the curtain shield airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.