Home › ENGINE · 3ZR-FAE › ENGINE CONTROL SYSTEM › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER


    A208126E01
  1. Visually check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

    OK:
    There is no foreign matter.

    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)
    If the result is not as specified, replace the mass air flow meter.



    A127786E24
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (THA) - 2 (E2)
    -20°C (-4°F)
    13.6 to 18.4 kΩ
    1 (THA) - 2 (E2)
    20°C (68°F)
    2.21 to 2.69 kΩ
    1 (THA) - 2 (E2)
    60°C (140°F)
    0.493 to 0.667 kΩ

    Text in Illustration 
    *1
    Component without harness connected
    (Mass Air Flow Meter)
    If the result is not as specified, replace the mass air flow meter.