Home › ENGINE · 3ZR-FAE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    A093604E09
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    80°C (176°F)
    0.310 to 0.326 kΩ

    Text in Illustration 
    *1
    Component without harness connected
    (Engine Coolant Temperature Sensor)

    NOTICE:
    When checking the engine coolant temperature sensor in water, do not allow water to contact the terminals. After completing the check, dry the sensor.

    If the result is not as specified, replace the sensor.