Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the seat in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the connectors under the seat.

  1. Connect the cable to the negative (-) battery terminal.



    B131273E01
  1. Operate the power seat switch knob and move the seat to the rearmost position.

  1. Install the 2 bolts to the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the 2 bolts in the order indicated in the illustration.



    B131274E01
  1. Operate the power seat switch knob and move the seat to the foremost position.

  1. Install the 2 bolts to the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the 2 bolts in the order indicated in the illustration.



    B139933
  1. Install the front seat track bracket outer cover in the direction indicated by the arrow in the illustration and attach the 2 claws.



    B139934
  1. Install the front seat track bracket inner cover in the direction indicated by the arrow in the illustration and attach the 2 claws.



2. INSTALL FRONT SEAT HEADREST ASSEMBLY


3. CHECK SRS WARNING LIGHT
Check the SRS warning light (Click here).


4. INSPECT FRONT SEAT ASSEMBLY
  1. Check the power seat operation.

  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch on (IG).

    2. Push the seat heater switch ON.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.