Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    A137899
  1. Remove the 9 clips and cover.



2. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


4. REMOVE V-BANK COVER SUB-ASSEMBLY


    A137900
  1. Detach the 3 clips and remove the V-bank cover.



5. DISCONNECT RADIATOR RESERVE TANK ASSEMBLY


    A178054
  1. Remove the 2 bolts and disconnect the reservoir tank.



6. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.



7. REMOVE REAR ENGINE UNDER COVER RH
  1. Remove the 2 clips and under cover.



8. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A129514E01
  1. Remove the 4 bolts and reinforcement.



9. REMOVE V-RIBBED BELT


    A137895
  1. Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.



    A095070E01
  1. While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.



10. REMOVE NO. 1 COOLER REFRIGERANT SUCTION HOSE


H102039
  1. Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



11. REMOVE NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


H102036
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



12. REMOVE COOLER COMPRESSOR ASSEMBLY


    H102369
  1. Disconnect the connector.

  1. Remove the 4 bolts and cooler compressor.



13. REMOVE CRANKSHAFT POSITION SENSOR


    A106634
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.