AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
![]() |
DTCs which are stored in the ECM can be displayed with the intelligent tester.
The intelligent tester can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Confirm the DTCs and freeze frame data and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC |
When using the intelligent tester:
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.
![]() |
When not using the intelligent tester:
Disconnect the battery terminal or remove the EFI MAIN and ETCS fuses from the engine room No. 1 relay block and engine room No. 1 junction block for 60 seconds or more. However, if you disconnect the battery terminal, perform the "INITIALIZATION" procedure (Click here).