AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| MEASURE LINE PRESSURE |
![]() |
Warm up the ATF.
Remove the test plug on the transaxle case center right side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
Perform the measure line pressure test again with the shift lever on R.
| Condition | Shift Lever on D | Shift Lever on R |
| Idling | 372 to 412 kPa (3.8 to 4.2 kgf/cm2, 54 to 60 psi) | 672 to 742 kPa (6.9 to 7.6 kgf/cm2, 97 to 108 psi) |
| Stall | 931 to 1,031 kPa (9.5 to 10.5 kgf/cm2, 135 to 150 psi) | 1,768 to 1,968 kPa (18.0 to 20.0 kgf/cm2, 256 to 285 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|