AUTOMATIC TRANSAXLE SYSTEM > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
![]() |
Measure the line pressure.
Warm up the ATF (Automatic Transmission Fluid).
Lift the vehicle up.
Remove the engine under cover.
Connect the intelligent tester to the DLC3.
Remove the test plug A on the transaxle case front left side and install SST.
Start the engine.
Using intelligent tester, shift to D position and hold 3rd gear by active test, and measure the line pressure in idling.
| Condition | D position kPa (kgf/cm2, psi) |
| Idling | 372 to 412 kPa (3.8 to 4.2 kgf/cm2, 54 to 60 psi) |
Turn the ignition switch off.
Disconnect the connector of the transmission wire.
Start the engine.
Firmly depress the brake pedal, shift to the D position, depress the accelerator pedal all the way down and check the line pressure while the stall test is performed.
| Condition | D position kPa (kgf/cm2, psi) |
| Stall test | 931 to 1,031 kPa (9.5 to 10.5 kgf/cm2, 135 to 150 psi) |
Turn the ignition switch off.
Remove SST, and install the test plug A.
Remove the test plug B, install SST and start the engine.
Connect the transmission wire connector, depress the brake pedal firmly, shift to the R position and check the line pressure while the engine is idling and during the stall test.
| Condition | R position kPa (kgf/cm2, psi) |
| Idling | 672 to 742 kPa (6.9 to 7.6 kgf/cm2, 97 to 108 psi) |
| Stall test | 1,768 to 1,968 kPa (18.0 to 20.0 kgf/cm2, 256 to 285 psi) |
Remove SST, and install the test plug B.
Clear the DTC.
| Problem | Possible cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|