AUTOMATIC TRANSAXLE SYSTEM > MANUAL SHIFTING TEST |
| MANUAL SHIFTING TEST |
![]() |
Disconnect the connector of the transmission wire.
Drive with the transmission wire disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.
| Shift Lever Position | Shifting Condition |
| L ←→ 2 | Not Shift (Not Change) |
| 2 ←→ 3 | Down Shift ←→ Up Shift |
| 3 ←→ 4 ←→ D | Not Shift (Not Change) |
Connect the connector of the transmission wire.
Clear the DTC (Click here).