AUTOMATIC TRANSAXLE SYSTEM > MANUAL SHIFTING TEST |
| MANUAL SHIFTING TEST |
![]() |
Turn the ignition switch off.
Disconnect the transmission wire connector.
Warm up the engine.
Drive the vehicle.
Shifting the shift lever in the order of L, 2, 3 and D position to check whether the shifting condition changes the table below.
| Shift Position | Shifting Condition |
| L to 2 | No shift (Not change) |
| 2 to 3 | No shift (Not change) |
| 3 to D | No shift (Not change) |
| D to 3 | No shift (Not change) |
| 3 to 2 | No shift (Not change) |
| 2 to L | No shift (Not change) |
Turn the ignition switch off.
Connect the transmission wire connector.
Clear DTCs (Click here).
| Shift Position | Gear |
| P | Parking |
| R | Reverse |
| N | Neutral |
| D | 3rd |
| 3 | 3rd |
| 2 | 3rd |
| L | 3rd |