P0711
| (2 trip detection logic): First, ECM checks for following conditions: (a) 17 minutes or more after engine is started and after 8 km (5 miles) or more of driving, ECT is -15°C (5°F) or more (b) After starting engine and certain period of time has elapsed, ECT and IAT are -15°C (5°F) or more If conditions are met, ECM then checks if ATF temperature is less than 20°C (68°F)*1 or less than 10°C (50°F)*2. If so, ECM interprets this as fault and illuminates MIL
- HINT:
- *1: for 1AZ-FE
- *2: for 2AZ-FE
Only for vehicles with 1AZ-FE engine and Euro-OBD specification (2 trip detection logic): First, ECM checks for following conditions: (a) ECT is 60°C (140°F) or more (b) After starting engine and certain period of time has elapsed, ECT is less than 35°C (95°F) If conditions are met, ECM then checks if ATF temperature is 100°C (212°F) or more. If so, ECM interprets this as fault and illuminates MIL.
| - Open or short in No. 1 ATF temperature sensor circuit
- No. 1 ATF temperature sensor
- ECM
|