DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0711 | Either condition is met: (A) Both (a) and (b) are detected (2-trip detection logic).
| ATF temperature sensor (transmission wire) |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If the value is -40°C (-40°F) or 150°C (302°F) or higher, the ATF temperature sensor circuit is open or short-circuited. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or higher | Short circuit |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0711) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSAXLE FLUID LEVEL |
Check the transaxle fluid level.
|
| ||||
| OK | ||
| ||