DTC P0766 Shift Solenoid "D" Performance (Shift Solenoid Valve S4) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0766 | Gear required by the ECM does not match the actual gear when driving (2 trip detection logic) |
|
| Item | Test Details | Diagnostic Note |
| Control the shift position | [Test Details] Operate the shift solenoid valve and set each shift lever position by yourself [Vehicle Condition]
| Possible to check the operation of the shift solenoid valves |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0766) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Display (DTC output) | Proceed to |
| Only P0766 is output | A |
| P0766 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE S4 |
![]() |
Remove the shift solenoid valve S4.
Measure the resistance between the solenoid valve terminal and solenoid valve body.
Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating noise.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 4.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly (Click here).
|
| ||||
| OK | ||
| ||