DTC P0778 Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0778 | Duty cycle to shift solenoid valve SL2 is 100% (1 trip detection logic) |
|

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL2) |
![]() |
Disconnect the B29 wire connector.
Measure the resistance of the transmission wire.
| Tester Connection | Condition | Specified Condition |
| 4 (SL2+) - 9 (SL2-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 4 (SL2+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| 9 (SL2-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM) |
Connect the B29 wire connector.
![]() |
Disconnect the B32 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| B32-58 (SL2+) - B32-59 (SL2-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| B32-58 (SL2+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| B32-59 (SL2-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SL2 |
![]() |
Remove the shift solenoid valve SL2.
Measure the resistance of the solenoid valve.
Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
|
| ||||
| OK | ||
| ||