Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0604    Internal Control Module Random Access Memory (RAM) Error

DTC    P0606    ECM / PCM Processor

DTC    P060A    Internal Control Module Monitoring Processor Performance

DTC    P060D    Internal Control Module Accelerator Pedal Position Performance

DTC    P060E    Internal Control Module Throttle Position Performance

DTC    P0657    Actuator Supply Voltage Circuit / Open

DTC    P1607    Cruise Control Input Processor

for Preparation Click here


DESCRIPTION

The ECM continuously monitors its internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check ensures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.
The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPU also perform continuous mutual monitoring. The ECM illuminates the MIL and set a DTC if: 1) outputs from the 2 CPUs are different or deviate from the standard, 2) the signals sent to the throttle actuator deviate from the standard, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.

DTC No.
DTC Detection Condition
Trouble Area
P0604
P0606
P060A
P060D
P060E
P0657
P1607
ECM internal error (1 trip detection logic)
ECM

INSPECTION PROCEDURE

Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
1.CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read the DTC.

Result:
Display (DTC output)
Proceed to
DTC P0604, P0606, P060A, P060D, P060E, P0657 and/or P1607 is output
A
DTC is not output
B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A

REPLACE ECM (Click here)