Home › ENGINE · 2AZ-FE › STARTING › STARTER CUT RELAY (w/ Entry and Start System)

STARTER CUT RELAY (w/ Entry and Start System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE STARTER CUT RELAY
  1. Remove the starter cut relay from the No. 7 relay block.



3. INSPECT STARTER CUT RELAY


    B060778E26
  1. Inspect the resistance of the relay.

    Standard resistance:
    Terminal Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL STARTER CUT RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL