DTC B2271 Ignition Hold Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2271 | IG1 relay actuation circuit or IG2 relay actuation circuit inside the main body ECU is abnormal. |
|

| 1.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Clear the DTCs.
Start the engine.
Allow the engine to idle for 1 minute or more.
Enter the following menus: Body / Main Body / DTC.
Read the DTCs.
| Result | Proceed to |
| B2271 | A |
| No DTC output | B |
|
| ||||
| A | |
| 2.INSPECT FUSE (AM2-2) |
Remove the AM2-2 fuse from the engine room No. 1 relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| AM2-2 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the E18 and E19 main body ECU connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E19-1 (AM1) - Body ground | Always | 11 to 14 V |
| E18-6 (AM2) - Body ground | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| E19-4 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||