DTC B2272 Ignition 1 Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2272 | IG1 relay actuation circuit inside the main body ECU or other related circuit is malfunctioning. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (IG1 RELAY MONITOR [INSIDE]) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnosis Note |
| IG1 Relay Monitor(Inside) | IG1 inner relay monitor/ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off | - |
|
| ||||
| OK | |
| 2.CHECK SWITCH CONDITION (ENGINE SWITCH) |
Make sure that the electrical key is inside the cabin.
With the shift lever in P, check that the power source mode changes as shown below each time the engine switch is pushed.
|
| ||||
| OK | ||
| ||
| 3.INSPECT IG1 RELAY |
![]() |
Remove the IG1 relay from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||