Home › ENGINE · 2AZ-FE › STARTING › ENTRY AND START SYSTEM

DTC    B2273    Ignition 2 Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction occurs in the IG output circuit, which is between the IG2 relay actuation circuit inside the main body ECU and the IG2 relay.

DTC Code
DTC Detection Condition
Trouble Area
B2273
IG2 relay actuation circuit inside the main body ECU or other related circuit is malfunctioning.
  1. Main body ECU
  2. IG2 relay
  3. Harness or connector

WIRING DIAGRAM


A165880E04


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (IG2 RELAY MONITOR [INSIDE])
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Read the display on the intelligent tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG2 Relay Monitor(Inside)
    IG2 inner relay monitor/ON or OFF
    ON: Engine switch on (IG)
    OFF: Engine switch off
    -

    OK:
    When the engine switch is turned on (IG), ON is displayed on the intelligent tester.



NG
Go to step 3
OK


2.CHECK SWITCH CONDITION (ENGINE SWITCH)
  1. Make sure that the electrical key is inside the cabin.

  1. With the shift lever in P, check that the power source mode changes as shown below each time the engine switch is pushed.

    OK:
    off → on (ACC) → on (IG) → off



NG
GO TO POWER SOURCE MODE DOES NOT CHANGE (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.INSPECT IG2 RELAY


    B060778E04
  1. Remove the IG2 relay from the engine room No. 1 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher



NG
REPLACE IG2 RELAY
OK


4.CHECK HARNESS AND CONNECTOR (IG2 RELAY - MAIN BODY ECU AND BODY GROUND)


    A126726E05
  1. Remove the IG2 relay from the engine room No. 1 relay block.

  1. Disconnect the E19 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Relay block IG2 relay terminal 1 - E19-5 (IG2D)
    Always
    Below 1 Ω
    Relay block IG2 relay terminal 2 - Body ground
    Always
    Below 1 Ω
    Relay block IG2 relay terminal 1 or E19-5 (IG2D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)