DTC B2274 ACC Monitor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2274 | ACC relay actuation circuit inside the main body ECU or other related circuit is malfunctioning. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (ACC RELAY MONITOR) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ACC Relay Monitor | ACC relay monitor/ON or OFF | ON: Engine switch on (ACC) OFF: Engine switch off | - |
|
| ||||
| OK | |
| 2.CHECK SWITCH CONDITION (ENGINE SWITCH) |
Make sure that the electrical key is inside the cabin.
With the shift lever in P, check that the power source mode changes as shown below each time the engine switch is pushed.
|
| ||||
| OK | ||
| ||
| 3.INSPECT ACC RELAY |
![]() |
Remove the ACC relay from the No. 5 relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (ACC RELAY - MAIN BODY ECU AND BODY GROUND) |
![]() |
Remove the ACC relay from the No. 5 relay block.
Disconnect the E18 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Relay block ACC relay terminal 1 - E18-4 (ACCD) | Always | Below 1 Ω |
| Relay block ACC relay terminal 2 - Body ground | Always | Below 1 Ω |
| Relay block ACC relay terminal 1 or E18-4 (ACCD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||