DTC B2282 Vehicle Speed Signal Malfunction |
DTC B2283 Vehicle Speed Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2282 | Both conditions are met:
|
|
| DTC Code | DTC Detection Condition | Trouble Area |
| B2283 | Both conditions are met:
|
|


| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed Signal | Vehicle speed signal/STOP or RUN | STOP: Vehicle is stopped RUN: Vehicle is running | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - COMBINATION METER) |
![]() |
Disconnect the IC instrument panel junction block connector.
Disconnect the E22 combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IC-8 (SPD) - E22-39 (+S) | Always | Below 1 Ω |
| IC-8 (SPD) or E22-39 (+S) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU (instrument panel junction block) with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||