Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the supplemental restraint system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK MULTIPLEX COMMUNICATION SYSTEM*
    1. Check the DTC.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    CHECK MULTIPLEX COMMUNICATION CIRCUIT
    A


    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Check the DTC.
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    CHECK CAN COMMUNICATION CIRCUIT
    A


    5.WARNING LIGHT CHECK

      NEXT


      6.CHECK DTC (Present and Past DTCs)*
      1. Check the DTC.
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      PROBLEM SYMPTOMS TABLE
      A


      7.DTC CHART

        NEXT


        8.CIRCUIT INSPECTION

          NEXT


          9.REPAIR

            NEXT


            10.CLEAR DTC (Present and Past DTCs)*

              NEXT


              11.CHECK FOR DTC (Present and Past DTCs)*
              1. Check the DTC.
                Result 
                Result
                Proceed to
                DTC is not output
                A
                DTC is output
                B



              B.
              Go to step 7

              12.CONFIRMATION TEST

                NEXT

                END