Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > CHECK MODE PROCEDURE

for Preparation Click here



CHECK MODE (SIGNAL CHECK)


    B127990E01
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch on (IG).

  3. Select the "SIGNAL CHECK", continue checking with the intelligent tester.

    NOTICE:
    Select the "SIGNAL CHECK" from the "DTC CHECK" screen displayed on the intelligent tester to clear the output DTCs (both present and past).

    HINT:
    1. Check mode is more sensitive to malfunctions than normal mode.
    2. If the normal system code is output in normal mode even when a sensor signal malfunction is suspected, perform the inspection in check mode.