Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INTAKE AIR SURGE TANK ASSEMBLY
  1. Remove the intake air surge tank assembly (Click here).



3. REMOVE VVT SENSOR


A173735E01
  1. Disconnect the 4 sensor connectors.

  1. Remove the 4 bolts and 4 sensors.