DTC B2285 Steering Lock Position Signal Circuit Malfunction |
DTC B2288 Steering Lock Signal Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2285 | Cable and LIN signals between the main body ECU and steering lock ECU are inconsistent. |
|
| B2288 | After turning the engine switch from off to on (IG), the steering wheel does not unlock for a certain period of time. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (STEERING LOCK CONDITION) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Steering Unlock Switch | Steering lock condition/ON or OFF | ON: Steering is unlocked OFF: Steering is locked | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - STEERING LOCK ECU) |
![]() |
Disconnect the E18 main body ECU connector.
Disconnect the E6 steering lock ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E18-18 (SLP) - E6-4 (SLP1) | Always | Below 1 Ω |
| E18-18 (SLP) or E6-4 (SLP1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU (instrument panel junction block) with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||