DTC B2286 Runnable Signal Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2286 | Cable information and CAN information between the main body ECU and ECM are inconsistent. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE CONDITION) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Engine Condition | Engine condition/RUN or STOP | RUN: Engine running STOP: Engine stopped | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM) |
![]() |
Disconnect the E20 main body ECU connector.
Disconnect the A12 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E20-2 (TACH) - A12-15 (TACH) | Always | Below 1 Ω |
| E20-2 (TACH) or A12-15 (TACH) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK WHETHER ENGINE STARTS |
Temporarily replace the main body ECU (instrument panel junction block) with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||