Home › ENGINE ยท 3ZR-FAE › STARTING › IGNITION SWITCH (w/o Entry and Start System)

IGNITION SWITCH (w/o Entry and Start System) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. INSTALL IGNITION SWITCH ASSEMBLY


  1. for CVT:



      A194726
    1. Install the ignition switch with the 2 screws.

      Torque:
      1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



    2. A210297
    3. Attach the claw to connect the key interlock solenoid wire harness connector to the ignition switch connector.

    4. Attach the clamp to connect the wire harness.

    5. Connect the ignition switch connector.



  1. for Manual Transaxle:



      A210296
    1. Install the ignition switch with the 2 screws.

      Torque:
      1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



    2. A210298
    3. Connect the ignition switch connector.

    4. Attach the clamp to connect the wire harness.



2. INSTALL LOWER STEERING COLUMN COVER


    A212631
  1. Attach the 4 claws to install the lower steering column cover.