Home › ENGINE · 3ZR-FAE › STARTING › IGNITION SWITCH (w/o Entry and Start System)

IGNITION SWITCH (w/o Entry and Start System) > INSPECTION

for Preparation Click here



1. INSPECT IGNITION SWITCH ASSEMBLY


    G035048E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    -
    LOCK
    10 kΩ or higher
    2 (AM1) - 3 (ACC)
    ACC
    Below 1 Ω
    2 (AM1) - 3 (ACC)
    2 (AM1) - 4 (IG1)
    6 (IG2) - 7 (AM2)
    ON
    Below 1 Ω
    1 (ST1) - 2 (AM1)
    1 (ST1) - 4 (IG1)
    6 (IG2) - 7 (AM2)
    6 (IG2) - 8 (ST2)
    START
    Below 1 Ω

    If the result is not as specified, replace the ignition switch assembly.