Home › ENGINE ยท 1AZ-FE › STARTING › IGNITION SWITCH (w/o Entry and Start System)

IGNITION SWITCH (w/o Entry and Start System) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE STEERING COLUMN COVER LOWER


    A134309
  1. Detach the 4 claws, release the tilt lever and remove the steering column cover lower.



3. REMOVE IGNITION SWITCH ASSEMBLY


    A124916
  1. Disconnect the ignition switch connector.

  1. Disconnect the ignition key cylinder light connector.



    A124915
  1. Remove the 2 screws and ignition switch.