Home › ENGINE ยท 3ZR-FAE › STARTING › IGNITION SWITCH (w/o Entry and Start System)

IGNITION SWITCH (w/o Entry and Start System) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. REMOVE LOWER STEERING COLUMN COVER


    A212631
  1. Detach the 4 claws, release the tilt lever and remove the lower steering column cover.



2. REMOVE IGNITION SWITCH ASSEMBLY


  1. for CVT:



      A210297
    1. Disconnect the ignition switch connector.

    2. Detach the claw and disconnect the key interlock solenoid wire harness connector from the ignition switch connector.

    3. Detach the clamp and disconnect the wire harness.



    4. A194726
    5. Remove the 2 screws and ignition switch.



  1. for Manual Transaxle:



      A210298
    1. Disconnect the ignition switch connector.

    2. Detach the clamp and disconnect the wire harness.



    3. A210296
    4. Remove the 2 screws and ignition switch.