FUEL TANK > INSTALLATION |
| 1. INSTALL FUEL TANK ASSEMBLY |
![]() |
Set the fuel tank on a transmission jack.
Lift up the transmission jack.
Fold back approximately half of any cushion rubber necessary for the attachment of the wire harness to the fuel tank.
Connect the fuel pump connector and sender gauge connector to the fuel tank.
Attach the wire harness to the 4 clamps.
![]() |
Install the 3 fuel tank bands with the 6 bolts.
| 2. INSTALL FUEL TANK FILLER PIPE |
Install the filler pipe with the 2 bolts.
Install the filler pipe protector with the 3 bolts.
| 3. CONNECT FUEL TANK TO FILLER PIPE HOSE |
![]() |
Connect the filler pipe hose to the fuel tank as shown in the illustration.
| 4. INSTALL FUEL HOSE PROTECTOR |
![]() |
Attach the claw to install the fuel hose protector to the filler pipe hose.
| 5. CONNECT FUEL TANK BREATHER HOSE |
![]() |
Connect the fuel tank breather hose to the fuel tank.
| 6. CONNECT AIR INLET LINE HOSE |
![]() |
Connect the air inlet line hose.
| 7. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Connect the main tube connector to the pipe. Push the 2 parts together firmly until a "click" sound is heard.
Connect the purge line hose to the pipe.
| 8. INSTALL NO. 1 FUEL TANK PROTECTOR |
Install the fuel tank protector with the 2 bolts.
Install the 2 clips and grommet.
| 9. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Install the parking brake cable with the 2 bolts.
| 10. INSTALL FUEL TANK CAP |
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. CHECK FOR FUEL LEAKS |
![]() |
Make sure that there are no fuel leaks after performing maintenance on the fuel system.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG), and push the intelligent tester main switch ON.
Select the Active Test mode on the intelligent tester.
Check that there are no leaks from the fuel system.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.