Home › ENGINE ยท 3ZR-FAE › FUEL › FUEL TANK

FUEL TANK > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge fuel system pressure (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



3. REMOVE FUEL TANK CAP


4. REMOVE FRONT FLOOR COVER


    A209090
  1. Remove the nut, bolt, 3 clips and floor cover.



5. REMOVE NO. 1 FLOOR UNDER COVER


    A209825
  1. Remove the 2 nuts, clip and floor under cover.



6. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY


    A131635
  1. Remove the 2 bolts and disconnect the parking brake cable.



7. REMOVE NO. 1 FUEL TANK PROTECTOR


    A128751
  1. Remove the 2 clips and grommet.

  1. Remove the 2 bolts and fuel tank protector.



8. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A124661E02
  1. Pinch and pull the main tube connector to disconnect the connector from the pipe.
    Text in Illustration 
    *1
    Pipe
    *2
    Fuel Tube Connector
    *3
    Retainer
    *4
    O-Ring
    *5
    Nylon Tube

    NOTICE:
    1. Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.
    2. Do not use any tools to separate the pipe and connector.
    3. Do not forcefully bend or twist the nylon tube.
    4. Check for foreign matter on the pipe seal surface. Clean if necessary.
    5. Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
    6. If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.

  1. Disconnect the purge line hose from the pipe.



9. REMOVE FUEL HOSE PROTECTOR


    A199132
  1. Detach the claw and remove the fuel hose protector from the filler pipe hose.



10. DISCONNECT FUEL TANK TO FILLER PIPE HOSE


A173328
  1. Disconnect the filler pipe hose from the fuel tank.



11. DISCONNECT FUEL TANK BREATHER HOSE


    A131627
  1. Disconnect the breather hose from the fuel tank.



12. DISCONNECT AIR INLET LINE HOSE


    A173329
  1. Remove the air inlet line hose.



13. REMOVE FUEL TANK FILLER PIPE
  1. Remove the 3 bolts and filler pipe protector.

  1. Remove the 2 bolts and filler pipe.



14. REMOVE FUEL TANK ASSEMBLY
  1. Set a transmission jack underneath the fuel tank.



    A124665
  1. Remove the 6 bolts and 3 fuel tank bands.

  1. Slightly lower the transmission jack.

    NOTICE:
    Be careful not to cut the wiring.



    A173331E01
  1. Fold back approximately half of any cushion rubber necessary for the detachment of the wire harness from the fuel tank in the step below.

  1. Disconnect the fuel pump connector and sender gauge connector.

    NOTICE:
    1. Before this procedure, check the connector for dirt, mud or other contamination.
    2. Do not use any tools in this procedure.

  1. Detach the wire harness from the 4 clamps and remove the fuel tank.