Home › ENGINE ยท 2AZ-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY


    A124921
  1. Install the starter with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



    A124920
  1. Connect the starter connector.

  1. Install the terminal nut and cover the nut with the cap.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }



2. INSTALL BATTERY BRACKET REINFORCEMENT


    A124919
  1. Install the bracket reinforcement.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



3. INSTALL FRONT BATTERY BRACKET


A124918
  1. Install the bracket front with the 4 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Attach the 2 wire harness clamps.



4. INSTALL BATTERY


5. INSTALL BATTERY INSULATOR


6. INSTALL BATTERY CLAMP


    A124917E01
  1. Attach the hook of the battery clamp to the battery bracket front.

  1. Temporarily tighten the nut and install the bolt.

  1. Adjust the battery clamp's position.

  1. Fully tighten the nut and bolt.

    Torque:
    17 N*m{ 168 kgf*cm , 12 in.*lbf } for bolt
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf } for nut

  1. Attach the 2 wire harness clamps.



7. CONNECT CABLE TO POSITIVE BATTERY TERMINAL


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL