Home › ENGINE ยท 2AZ-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL


3. REMOVE BATTERY CLAMP


    A124917E01
  1. Remove the bolt and loosen the nut.

  1. Detach the 2 wire harness clamps.

  1. Detach the hook of the battery clamp from the battery bracket front, and then remove the battery clamp.



4. REMOVE BATTERY INSULATOR


5. REMOVE BATTERY


6. REMOVE FRONT BATTERY BRACKET


    A124918
  1. Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and bracket front.



7. REMOVE BATTERY BRACKET REINFORCEMENT


A124919
  1. Remove the 2 bolts and reinforcement bracket.



8. REMOVE STARTER ASSEMBLY


    A124920
  1. Disconnect the starter connector.

  1. Open the terminal cap, remove the nut and disconnect the starter wire.



    A124921
  1. Remove the 2 bolts and starter.