Home › ENGINE ยท 2AZ-FE › STARTING › STARTER (for 1.7 kW Type)

STARTER (for 1.7 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNETIC SWITCH ASSEMBLY


    A079718
  1. Remove the nut and disconnect the lead wire from the magnetic switch.



    A079719
  1. Remove the 2 screws holding the magnetic switch to the starter drive housing.

  1. Remove the magnetic switch.

  1. Remove the return spring and plunger from the starter drive housing.



2. REMOVE STARTER YOKE ASSEMBLY


    A079720
  1. Remove the 2 through-bolts, and pull out the starter yoke together with the commutator end frame.



    A079721
  1. Remove the starter yoke from the commutator end frame.



3. REMOVE STARTER ARMATURE PLATE


    A079722
  1. Remove the armature plate from the starter yoke.



4. REMOVE STARTER COMMUTATOR END FRAME COVER


    A079723
  1. Using a screwdriver, pry out the commutator end frame cover.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A082440E03
  1. Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the armature from the commutator end frame.



6. REMOVE PLANETARY GEAR


    A081167
  1. Remove the 3 planetary gears from the starter drive housing.